In addition to our original series of plated steel MPB's we are pleased to introduce a new low profile cap.
Great for counter and desk top or any type of "riser" use. These are made of aluminum rod, then anodized.
How To Order:
First select your cap diameter in Step 1.
Depending on your cap selection, the dropdown menus for subsequent
steps will become active. After completing steps, towards the bottom of
this page, add configured kit to the shopping cart.
Prices are per each kit. Please
contact Customer Service @ 800-523-1269 with any questions, to order 50+ quantities,
or if you wish to order additional components.
Step 1. Please Select Cap Diameter:
Please note that the low profile caps require a 17/32" hole to properly fit into the material. The minimum recommended material thickness for use with the low profile caps is 1/4".
click to enlarge
Step 2. Please Select a Screw Connector Length (Included in
Price of Cap Except Where Marked (*):
Step 3. Please Select a Barrel Height:
For MPB12 (not recommended for wall mounting)
Step 4. Please Select Type of Mounting Hardware (Included in Price Except
Where Marked (*):
Wood Mount Hanger Screw For Stud Wall
Anchor For Concrete Wall
(available only for MPB9, MPB10 or MPB11)
Anchor For Drywall
Tabletop Screw With Washer
Step 5. Optional Corner Hub Spacers to secure panels to
stand-off. No panel drilling required. Additional cost.
(Available for MPB10 & MPB11 only):