Designed by: Clint Strong - Dallas, Texas.

Power Track raceway system is back! New features include lower angle MDF ramps and new end caps. Low profile ramps meet ADA regulations for wheelchair accessibility. Bringing power and data to your workstation has never been easier. No more tripping hazards or unsightly wires – blends seamlessly with your own carpet and channels cabling underneath.

Ideal for a conference table, credenza or freestanding desk. It is a single linear system which can extend 20 ft or more, and can be cut to your specific length in the field.

The receptacle connects at end of track and has two 15A/110VAC electrical receptacles, and two empty slots that can be used for voice, data or A/V jacks. The electrical outlets are attached to 24 ft of flexible conduit for 4 ft length of track. Comes standard with an unloaded black data insert tree: PCS/DT-90.

Cap finishes: Espresso, Graphite, Stone and Satin Aluminum.

General installation: Tracks and ramps are installed onto floor. Power is connected to building by a licensed electrician through a small hole in wall or column. The power/data components are placed in the raceway and the cover snapped on. Lastly the floor covering is installed over the ramps. Done! Quick and easy. Full installation instructions are included with package shipment or click here for a downloadable Installation Guide.

Electrical codes vary by location. Please check with your electrician to verify that this unit meets your local code before installing.