Replacing the PTRC1, this new and improved version is now just 0.75" high and incorporates low-sloping moisture-resistant MDF ramps, which are eco-friendly and ADA compliant. Plus, with the accessible wireway cap with modular data options, keeping up with the latest technology is a snap.
PTRC2 comes in two versions, one of which should meet your needs.
: Ideal for a conference table, credenza or free standing desk. It is a single linear system which can extend 20 feet or more, and can be cut to your specific length in the field. The receptacle connects at the end of the track and has two 15A/125VAC power receptacles, and two voice/data ports, which will accommodate voice/data jacks or A/V jacks.
Please note that the PTRC2/A has been discontinued and is limited to stock on hand.
: Designed specifically for modular furniture/systems/cubicles, this version has a steel junction box which hard wires to your furniture base power feed. In addition, multiple sets of work stations can be joined. It features 8-wire 4-circuit power, which can support six to eight work stations, and has capacity for up to 18 Cat6 voice/data cables.
: High capacity power housing with 20A circuit load, ideal for bringing power from the wall to a conference table, credenza or free standing desk. It is a single linear system which can extend 20 feet or more, and can be cut to your specific length in the field. The receptacle connects at the end of the track and has two 20A/110VAC power receptacles, and two voice/data ports, which will accommodate voice/data jacks or A/V jacks.
Available in 4 ft. or 8 ft. lengths, or add an extension kit to reach your desired length.
Cap Finishes: Espresso, Graphite and Satin Aluminum.
available in 4 ft. or 8 ft. lengths and can be cut in the field to fit your specific requirements.
also available for changing direction with right angle turns left or right. 24 ft. cord.
Tracks and ramps are installed onto floor. Power is connected to building by a licensed electrician through a small hole in wall or column. The power/data components are placed in the raceway and the cover snapped on. Lastly the floor covering is installed over the ramps. Done! Quick and easy.
|UL listed and tested to meet UL514A (Metallic Outlet Boxes). UL File No. E139699. Electrical codes vary by location. Please check with your electrician to verify that this unit meets your local code before installing.|